<em id="b06jl"></em>
      <tfoot id="b06jl"></tfoot>
      <tt id="b06jl"></tt>

        1. <style id="b06jl"></style>

              狠狠干奇米,国产igao,亚卅AV,污污内射在线观看一区二区少妇,丝袜美腿亚洲综合,日日撸日日干,91色鬼,夜夜国自一区
              您好,歡迎來到易龍商務網!
              全國咨詢熱線:18656950366

              福建雨水混流泵采購價優惠報價 泰安金石泵業有限公司

              【廣告】

              發布時間:2020-08-19 16:19  






              混流泵

              (一)   用途:

              HW型混流泵為臥式、單級、單吸、懸臂蝸殼式混流泵,適用于農田排灌、工業、城鎮給排水及船塢、碼頭引水等。

              I.                  

              Application:

              HW Spiral

              Mixed-flow pump is a horizontal type, single stage, single suction and

              cantilever spiral mixed flow pump, which is used for farmland irrigation and drainage,

              industry, town water supply and drainage and water diversion of docks.

              (六)軸上的擋水圈可防止水沿泵軸流入軸承體內,從而保護軸承,處長使用壽命。

              VI.The water deflector of axile can stop the water

              running into the bearing body through the pump axile which

              can protect

              the bearing and lengthen the service life .

              (一)安裝原則

                1、安裝高度:視雨季或旱季不同情況具體考慮,要求吸上真空高度不超過泵的吸程。

                2、安裝位置的選擇:盡可能靠近水源,做到既保證安全、又縮短進水管路,減少揚程損失。

               

               


               2、水泵起動后有一股水就不出水了

               After starting ,

               the pump only send one stream water then no water runs out

               1、吸入的水中有過多氣泡

               2、吸水管中窩存空氣

               3、吸水管或連接處墊料不嚴密有進氣現象

               4、底閥或葉輪有水草雜物填塞

               1.There are too many bubbles in the

               indrawn water

               2.There is air in the suction pipes

               3.The paddings in connected parts are

               imprecision and produces leaking phenomenon

               4.There are waterweeds and sundries

               filled in the bottom valve or impeller

               1、檢查進水管末端是否在水平面以下一米左右

               2、排除空氣

               3、高速墊料,填塞縫隙擰緊螺栓

               4、消除水草雜物

               1.Check the end

               of water inlet pipe if it is under the water surface at one meter

               2. Remove the

               air

               3.Add padding to

               fill the gaps and then tighten the bolts

               4.Clear the

               waterweeds and sundries.



              行業推薦