輥道廠家高性價比的選擇

對于大型軋機來說，尤其是熱軋機必須用動力傳動輥道。多的還是集體傳動式，特別是長度不大而軋件斷面很大時，適宜用集體傳動。單獨傳動輥道通常用于長距離的軋件的傳送。

For large rolling mills, in particular, the hot rolling mill must be powered by a power drive roller. The most important is the collective transmission type, especially when the length is small and the section of the workpiece is very large, it is suitable for the use of collective transmission. The single drive roller is usually used for the transmission of long distance parts.

新式的高速熱軋機及連續式熱軋機一般都采用單獨傳動系統。包膠滾筒安裝方便包膠滾筒安裝起來特別的方便，不需要安裝好在送過去，現場進行安裝就可以了，滾筒也是不需要拆卸的，這樣是非常方便的，你只需要付錢、收獲、等著用就可以了，其他的都有專業的人士來干。單獨傳動優點很多，它的制作簡單，由于不需要傳動齒輪及傳動軸，從而大大簡化了輥道的機械結構，使裝拆、檢修和潤滑等問題也都大大簡化了，而且對輥子相互位置之準確度的要求也沒有集體傳動時那樣嚴格。

The new type of high speed hot rolling mill and continuous hot rolling mill generally use a separate transmission system. Individual drive has many advantages, making it simple, because it does not need the transmission gear and the transmission shaft, which greatly simplifies the mechanical structure of the roller, the assembly and disassembly, maintenance and lubrication problems are greatly simplified, and the accuracy of the location of each roller requirements are not as strict collective transmission.

皮帶輸送機的結構參數的優化方法皮帶輸送機的結構雖然受到了種種工況的限制，而輸送機的工作狀態是處于滿載正常運行的狀態，在常規設計計算方法完成后，可以進行采用離散變量優化的網絡法，對帶式輸送機參數進行優化設計 。

Optimization of the structural parameters of belt conveyer, the structure of belt conveyer is restricted by various working conditi, and the working state of the conveyor is in a state of full load. After the completion of the conventional design calculation method, the network method of discrete variable optimization can be used to optimize the parameters of the belt conveyor. Chemical design.