620軋機價格歡迎來電,圣霖國際客戶至上

開坯機為兩輥水平軋機，坯料送至軋機前后，根據軋制程序表進入相應的軋槽可逆軋制，并通過翻鋼裝置將軋件夾緊進行翻轉。一般軋制5-7道次(多9道次)。

The blooming machine is a two roll horizontal mill, and the billet is sent to the front and rear mills. According to the rolling schedule, the roll is rolled into the corresponding rolling groove, and the workpiece is clamped and turned through the turning device. The general rolling is 5-7 times (up to 9 times).

輥系快速整體更換不需吊車，采甩軋輥牽引小車和橫移臺車結合的換輥方式，導衛橫梁安裝在軋機軸承座上，更換軋輥時,導衛及橫梁隨輥系整套從牌坊窗口中拖出，一次換輥時間僅為20min.

You don't need to replace the whole fast roller roller way for mining crane, trolley and swing roller traversing trolley with the guide beam is installed on the bearing seat of rolling mill, roll changing, guide and beam with roll set pulled from the housing window, a roll change time is only 20min.

驅動電機斜置在鋸機底座上，通過傘齒輪及主傳動軸帶動鋸片，鋸片由液壓裝置鎖緊在傳動軸上。鋸片進鋸由液壓驅動，進鋸速度根據鋸切阻力由比例閥調節。當軋件斷面較大、鋸切阻力高時，進鋸速度慢，反之，進鋸速度塊。

The driving motor is inclined on the base of the saw machine, and the saw blade is driven through the bevel gear and the main drive shaft, and the saw blade is locked on the drive shaft by the hydraulic device. The sawing saw is driven by hydraulic pressure, and the speed of the saw is adjusted by the proportional valve according to the cutting resistance. When the section of the rolled piece is large and the cutting resistance is high, the speed of the saw is slow, and conversely, the speed block of the saw.

據說在14世紀歐洲就有軋機，但有記載的是1480年意大利人達·芬奇（Leonardo da Vinci）設計出軋機的草圖。1553年法國人布律列爾(Brulier)軋制出金和銀板材,用以制造錢幣。此后在西班牙、比利時和英國相繼出現軋機。

It is said that there are rolling mills in Europe in the fourteenth Century, but it is recorded that in 1480, Leonardo Da Vinci (Italian Italian designer Da Finch) designed the draft for rolling mills. In 1553 the French law Adler cloth (Brulier) rolled gold and silver plate, used in the manufacture of coins. Since then, rolling mills have been rolled out in Spain, Belgium and Britain.