reducer型號服務至上

齒輪減速機具有體積小，傳遞扭矩大的特點。齒輪減速機在模塊組合體系基礎上設計制造，有的電機組合、安裝形式和結構方案，傳動比分級細密，滿足不同的使用工況，實現機電一體化。

Gear reducer has the characteristics of small volume and large torque transmission. Gear reducer is designed and manufactured on the basis of modular combination system. There are very many motor combinati, installation forms and structural schemes. The transmission ratio is fine and classified to meet working conditi and achieve mechanical and electrical integration.

在輸出軸上安裝傳動件時，不允許用錘子敲擊，通常利用裝配夾具和軸端的內螺紋，用螺栓將傳動件壓入，否則有可能造成減速機內部零件的損壞。

When driving parts are installed on the output shaft, it is not allowed to knock with hammers. Usually use assembly jig and inner thread of shaft end to press the transmission parts into bolts with bolts, otherwise, it may cause damage to internal parts of reducer.

允許輸入法蘭：

不能大于或小于臨級減速機的標準尺寸，如減速機PLE80?的標準法蘭為80mm,其臨級的減速級是PLE60?和PLE120，PLE80?允許法蘭不應小于60mm,也不能大于120mm。

Allow input flange

It can't be greater than or less than the standard  of the reducer. For example, the standard flange of reducer PLE80 is 80mm, and the deceleration stage of its reducer is PLE60?隨著市場需求的不斷深化，讓減速機市場得到快速發展，當然減速機的品種也在不斷豐富。 PLE120, PLE80? The maximum allowable flange should not be less than 60mm, nor greater than 120mm.

對減速機箱體進行共振測試，找出共振位 置，增加適當?shù)慕顥l（板），可以提高箱體的剛度，減少箱體的振動，實現降噪。多級傳動時要求瞬時傳動比的變化盡量小，以保證傳動平穩，沖擊及振動小，噪聲低。

By testing the resonance of the reducer box, finding out the resonance  and adding appropriate ribs (plates), the stiffness of the box can be increased, the vibration of the box can be reduced and the noise can be reduced. In multistage transmission, the change of instantaneous transmission ratio should be as small as  to ensure stable transmission, low impact and vibration, and low noise.