冷床設備生產商咨詢客服「在線咨詢」

首先確定所需壓力的大小，主要取決于以下幾方面：被矯鋼材的品種、規格；待矯軋件的原始彎曲程度；待矯軋件的終軋溫度；被矯軋件的機械性能；矯直溫度等。

First, determine the size of the required pressure, which mainly depends on the following aspects: the varieties and specificati of the straightened steel, the original bending degree of the rolled piece, the finishing temperature of the rolled piece, the mechanical properties of the leveled piece, the straightening temperature and so on.

經常檢查相應輥面磨損情況，有積瘤的要及時清理；觀察進鋼情況，保證入口導位位置正確；經?？砍C直盤圓角與成品圓角；制定合理的矯直力，盡量避免回矯；合理控制冷卻過程；保證型鋼低于80℃進入矯直機；注意觀察各輥軸向、垂直竄動量，做到及時應對。

Always check the corresponding roller surface wear, a tumor of the product to clean up; on steel, ensure the ce guide the correct ; often straightening and finished plate fillet fillet; reasonable straightening force, try to avoid the back; the reasonable  of the cooling process; ensure the steel is lower than 80 DEG C into the straight machine; observe the roll axial and vertical movement, timely respe.

工藝過程是：線材出精軋機后先入水冷導管進行急冷，冷卻到650～750℃，經成圈器成圈后落入流態床中。流態床用流動的、導熱性好的粒料(鋯砂，含ZrO267.2%；在型材生產線上，冷床對型材還具有預彎曲功能，防止型材在自然冷卻過程中因各處質量不等導致出現不規則彎曲。SiO232.8%)作媒介，用鼓風機攪動這些顆粒呈懸浮運動狀態，如同鉛浴池中的鉛液沸騰一樣。

The process is as follows: after the wire is finished, the first step is to enter the water cooling pipe and then to cool it to 650~750 degrees. The flow bed is used as a medium for flowing, good thermal conductivity particles (zirconium sand, containing ZrO267.2%; SiO232.8%). The particles are stirred by the blower to move in suspension, just as the lead liquid in the lead bath is boiling.