reducer廠商推薦

允許輸入法蘭：

不能大于或小于臨級減速機的標準尺寸，如減速機PLE80?的標準法蘭為80mm,其臨級的減速級是PLE60?和PLE120，PLE80?允許法蘭不應小于60mm,也不能大于120mm。

Allow input flange

It can't be greater than or less than the standard  of the reducer. For example, the standard flange of reducer PLE80 is 80mm, and the deceleration stage of its reducer is PLE60? PLE120, PLE80?4、齒輪滲碳淬火熱處理工藝,采用獨特的低噪聲齒齒形設計,確保產品的使用壽命。 The maximum allowable flange should not be less than 60mm, nor greater than 120mm.

減速機的作用

1)降速同時提高輸出扭矩，扭矩輸出比例按步進電機輸出乘減速比，但要注意不能超出減速機額定扭矩。

2)速同時降低了負載的慣量，慣量的減少為減速比的平方。大家可以看一下一般電機都有一個慣量數值。

The function of the reducer

1) reduce the speed and increase the output torque at the same time. The ratio of the torque output to the multiplying and decelerating ratio of the stepper motor output, but we must be careful not to exceed the rated torque of the reducer.

2) speed reduces inertia of load at the same time, and inertia reduces to the square of deceleration ratio. As you can see, general motors have an inertia value.

減速電機分類：

1、大功率齒輪減速電機

2、同軸式斜齒輪減速電機

3、平行軸斜齒輪減速電機

4、螺旋錐齒輪減速電機

5、YCJ系列齒輪減速電機

Deceleration motor classification:

1. High power gear reducer

2, coaxial helical gear reducer

3, parallel axis helical gear deceleration motor

4, spiral bevel gear reducer

5, YCJ series gear deceleration motor