您好,歡迎來到易龍商務網!
發布時間:2020-10-29 02:45  
【廣告】





混流泵
(一) 用途:
HW型混流泵為臥式、單級、單吸、懸臂蝸殼式混流泵,適用于農田排灌、工業、城鎮給排水及船塢、碼頭引水等。
I.
Application:
HW Spiral
Mixed-flow pump is a horizontal type, single stage, single suction and
cantilever spiral mixed flow pump, which is used for farmland irrigation and drainage,
industry, town water supply and drainage and water diversion of docks.

4、耗用功率太大
The power
cumption is too large
1、轉速太高
2、傳動軸彎曲
3、填料壓得太緊
4、軸承磨損或損壞
5、葉輪和前蓋摩擦
6、皮帶太緊
1.The rotate speed is too high
2.The drive shaft is bend
3.The padding is too tight
4.The bearing is worn out
5.Impeller clashes the front cover
6.The belt is too tight
1、降低轉速
2、校直
3、擰松壓蓋螺栓或將填料取出打扁一些
4、更換軸承
5、調整葉輪端面軸向間隙
6、適應放松
1.Reduce the rotate speed
2.Straightening
3.Loose the cap blot or take our the
padding and make it more flat
4.Change the bearing
5.Ajust the end play of impeller end face
6.Loose the belt to suitable degree
S型泵性能范圍流量160~18000立方米/時,揚程12~125米,進水口直徑150~1400毫米,轉速2950、1450、970、730、585、485、360轉/分。
(1)D型泵性能范圍 流量6.3~720立方米/時,揚程16~600米,進水口徑:50、75、100、125、150、200毫米,其中50~125毫米泵型為高轉速2950轉/分,150~200毫米泵型轉速為1480轉/分。
(2)結構型式 D型多級離心泵為臥式多級(2~12級),葉輪為單吸,泵體為分段式。當首級葉輪為雙吸時,用DS表示,當同時規定有兩種轉速時,低速用DA表示,用于鍋爐給水的多級離心泵,用DG表示。
無法啟動
首先應檢查電源供電情況:接頭連接是否牢靠;開關接觸是否緊密;保險絲是否熔斷;三相供電的是否缺相等。如有斷路、接觸不良、保險絲熔斷、缺相,應查明原因并及時進行修復。其次檢查是否是水泵自身的機械故障,常見的原因有:填料太緊或葉輪與泵體之間被雜物卡住而堵塞;泵軸、軸承、減漏環銹住;泵軸嚴重彎曲等。排除方法:放松填料,疏通引水槽;拆開泵體清除雜物、除銹;拆下泵軸校正或更換新的泵軸。(2)由于離心泵靠葉輪進口形成真空吸水,因此在起動前必須向泵內和吸水管內灌注引水,或用真空泵抽氣,以排出空氣形成真空,而且泵殼和吸水管路必須嚴格密封,不得漏氣,否則形不成真空,也就吸不上水來。