沈陽reducer價格信賴推薦

在輸出軸上安裝傳動件時，不允許用錘子敲擊，通常利用裝配夾具和軸端的內螺紋，用螺栓將傳動件壓入，否則有可能造成減速機內部零件的損壞。

When driving parts are installed on the output shaft, it is not allowed to knock with hammers. Usually use assembly jig and inner thread of shaft end to press the transmission parts into bolts with bolts, otherwise, it may cause damage to internal parts of reducer.

通常齒輪減速機已廣泛應用于冶金、礦山、起重、運輸、水泥、建筑、化工、紡織、印染、制藥、等領域。但在這種齒輪減速機的使用有一定的限制,所以,讓我們了解下使用時需要注意什么。

1、高速旋轉不超過1500 r / min。齒輪減速器。

2、齒輪圓周速度不超過20 m / s。

Usually gear reducer has been widely used in metallurgy, mining, lifting, transportation, cement, ctruction, chemical, textile, printing and dyeing, pharmaceutical, and other fields. But there are some restricti on the use of this gear reducer, so let us know what to pay attention to when using it.

1. The high speed rotation does not exceed 1500 R / min. Gear reducer.

2, the circumferential speed of the gear is not more than 20 m / S.

減速機內部齒面硬度 隨著齒輪硬齒面技術的發展，其承載能力大、體積小、重量輕、傳動精度高等特點使其應用領域日趨廣泛。但為獲得硬齒面采用的滲碳淬硬使齒輪產生變形，導致齒 輪傳動噪聲增大，壽命縮短。

With the development of hard tooth surface technology, the internal hardness of gear reducer has been widely used because of its large bearing capacity, small volume, light weight and high transmission accuracy. But the carburizing and hardening used to obtain the hard tooth surface causes the deformation of the gear, which results in the increase of the noise of the gear transmission and the shortening of the service life.