crane生產品牌企業【圣霖國際】

實踐表明，帶雙鍍槽的軸頭在使用過程中，鑲槽壁容易崩裂，目前常用易加工的帶平臺的袖頭代替雙因槽的抽頭。

直徑超過400mm的冷軋軋輥，在鍛造后，多半在中心饅一個670一250mm的通7L。這樣，一力面可以使軋輥經熱處理店的內應力分朽均勾；另一方面在軋輥表面淬火時，可對軋輥通水冷卻，提高淬火效果。

Practice shows that, with double bath head is in use, insert groove wall is easy to crack, at present common processing platform with the cuff instead of double slot for tap.

Cold roll diameter of more than 400mm, after forging, mostly in the 7L center. A 670 250mm. So, on one hand can make the roller stress heat treatment shop allocation hook are; on the other hand, the roll surface quenching, the water cooling roller, improve the quenching effect.

軋輥的無損檢測通常用超聲波探傷儀進行。冷軋輥探傷標準中通常把輥身依受力情況分成表面區、中心區和中間區，然后依斷裂力學原理分別規定各區允許存在的缺陷的臨界尺寸。

Nondestructive testing of rolls is usually carried out by ultrasonic flaw detectors. In the testing standard of cold roll, the roll body is usually divided into the surface area, the center area and the middle area according to the force condition, and then the critical dimensi of the defects are allowed in each area according to the principle of fracture mechanics.

（1）堆焊前需先將軋輥輥身表面的疲勞層或缺陷，尤其是裂紋必須徹底清除；  

（2）在堆焊時，為了防止裂紋的產生，必須先加工軋輥輥身預熱，預熱溫度根據軋輥輥及堆焊材料而定。

(1) before welding, the fatigue layer or defect of the roller body surface must be first removed, especially the crack must be thoroughly removed.

(2) in the process of surfacing, in order to prevent cracks, the roller body must be pre heated, and the preheating temperature should be determined according to roll rolls and surfacing materials.

生產長材產品的軋機種類繁多，因此，軋機類型的選擇、布局，軋輥材質的選擇、軋輥尺寸的確定，選擇范圍也非常廣。同時，不同的軋機所選擇的軋輥也是不相同的，需要根據生產要求選擇軋輥。

There are a wide variety of rolling mills to produce long timber products. Therefore, the selection and layout of the type of rolling mill, the selection of the material of the roll and the determination of the size of the roll are also very wide. At the same time, the rolls chosen by  rolling mills are also the roller should be selected according to the production requirements.