500rolling mill承諾守信【圣霖國際】

上軋輥為液壓式平衡裝置，電動壓下，壓下量480mm，壓下速度60mm／s，正常軋制時下輥固定，上輥壓下。換品種和使用較小直徑的軋輥時，下軋輥用墊片組調節其水平度.

The upper roller is the hydraulic balance device, the electric press down, the press down 480mm, the down speed 60mm / s, the normal rolling roll fixed and the upper roller. When changing varieties and using smaller diameter rolls, the lower roll can be adjusted by the gasket group.

在軋機設置了上軋輥動態軸向調整。軋機調零后，可以測量和存儲上探頭到上輥軸及下探頭到下輥軸的距離。軋制過程中立輥如失去平衡而引起上輥或下輥的竄動，上輥會與下輥同步調整，從而保證上、下腹板對中并控制腹板和翼緣的尺寸。

There is a dynamic axial adjustment of the upper roll on the universal rolling mill. After the rolling mill is zero, the distance between the upper roll shaft and the lower probe can be measured and stored. During the rolling process, if the neutral rolls lose balance, the upper roller or the lower roll will move. The upper roller will synchronize with the lower roller, so as to ensure the upper and lower plate alignment and  the dimensi of web and flange.

據說在14世紀歐洲就有軋機，但有記載的是1480年意大利人達·芬奇（Leonardo da Vinci）設計出軋機的草圖。1553年法國人布律列爾(Brulier)軋制出金和銀板材,用以制造錢幣。此后在西班牙、比利時和英國相繼出現軋機。

It is said that there are rolling mills in Europe in the fourteenth Century, but it is recorded that in 1480, Leonardo Da Vinci (Italian Italian designer Da Finch) designed the draft for rolling mills. In 1553 the French law Adler cloth (Brulier) rolled gold and silver plate, used in the manufacture of coins. Since then, rolling mills have been rolled out in Spain, Belgium and Britain.

楔橫軋工藝的基本原理是，將加熱后的棒材送入兩個同向旋轉的帶有楔性凸起的模具中間，棒材在模具的帶動下，作與模具反向的回轉運動，同時材料發生徑向壓縮變形和軸向延伸變形，從而成形階梯軸類零件。

The basic principle of the cross wedge rolling process is to send the heated bar into the middle of two same revolving moulds with wedge-shaped protrusi. The rod is driven by the mold to make the reverse rotation movement with the mold. At the same time, the material has radial compression deformation and axial extension deformation, thus forming a staircase type part.